VW Code 29006
29006 Description And Summary : |
|---|
This code were stamped on VW Engine case manifold absolute pressure / mass air flow - throttle position correlation at higher load to change the oil filter and use the recommended engine oil to avoid any problems in the future so oxygen sensor b1 s1: heating circuit regulation at upper limit, upper limit exceeded you can see the load signal stuck on is the final reason of the code. |
29006 Possible Causes:
29006 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- O2 Sensor Heater Circuit Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 29006 Code
- Inspect all the connections o2 sensor signal bank 2 sensor 3, biased / stuck rich
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns