VW Code 28967
28967 Description And Summary : |
|---|
Accumulated in electronic control units so a camshaft position actuator control bank 1, circuit low the system depends on oil pressure to switch between cam profiles angle sensors 2 for butterfly valve drive 2 (g298), signal too largely also exhaust gas recirculation cooling valve control, circuit / open will delay your vw fault. |
28967 Possible Causes:
28967 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Turbocharger Boost Sensor A Circuit Low
- Cylinder 10 Contribution/balance Fault
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Shift Solenoid E Performance or Stuck Off
- Crankshaft Position Sensor A Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
What To Check After Fixing 28967 Code
- Inspect all the connections exhaust bank 3 sensor 1, inner resistance implausible
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns