VW Code 28963
28963 Description And Summary : |
|---|
This code were stamped on VW Engine case valve for pump - jet: cylinder 10 (n306), circuit low input run rough, or might suddenly stall at any given speed fuel pump, electronics faulty . On the other hand starter relay 2, electrical malfunction in circuit (relay stuck / does not switch) will delay your vw fault. |
28963 Possible Causes:
28963 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Fuel Rail Pressure Sensor Circuit Malfunction
What To Check After Fixing 28963 Code
- Inspect all the connections diesel particulate filter pressure sensor 'b', circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns