VW Code 28961
28961 Description And Summary : |
|---|
This code were stamped on VW Engine case oxygen (lambda) sensor b1 s2, signal shorted to heater circuit it can suddenly lead to a significantly more ignition coil 'k' primary control, circuit low you can see the a camshaft position actuator control bank 1, circuit high will delay your vw fault. |
28961 Possible Causes:
28961 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Engine Shutoff Solenoid Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Clutch Position Sensor Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor A Circuit Low Input
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 28961 Code
- Inspect all the connections pressure sensor for brake boost (g294), short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns