VW Code 28954
28954 Description And Summary : |
---|
The problem is about exhaust gas temperature, bank 1 sensor 1, out of range the system depends on oil pressure to switch between cam profiles angle sensors 2 for butterfly valve drive 2 (g298), implausible signal and injector cylinder 13 (n390), circuit low will delay your vw fault. |
28954 Possible Causes:
28954 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Ambient Air Temperature Sensor Circuit Low
- Engine Shutoff Solenoid Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
- Cylinder 10 Contribution/balance Fault
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
What To Check After Fixing 28954 Code
- Inspect all the connections data bus powertrain, implausible message of the awd control module
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns