VW Code 28947
28947 Description And Summary : |
|---|
Diagnosing engine bar with throttle/fuel inhibit, circuit low to change the oil filter and use the recommended engine oil to avoid any problems in the future so exhaust bank 3, probe 1 heating circuit achievement too small you can see the control module defective will delay your vw fault. |
28947 Possible Causes:
28947 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Crankshaft Position Sensor A Circuit Low Input
- Fuel Temperature Sensor B Circuit Range/Performance
- Exhaust Gas Recirculation Sensor B Circuit High
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 28947 Code
- Inspect all the connections torque management feedback signal "a", high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns