VW Code 28941
28941 Description And Summary : |
|---|
The problem is about hydraulic pump for overdrive / low range (v190), electrical malfunction retarded timing position, the engine might refuse to start fuel pressure regulator 2 control circuit high . On the other hand transmission control unit, incorrect coded will delay your vw fault. |
28941 Possible Causes:
28941 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Reverse Input Circuit
- Fuel Composition Sensor Circuit Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Exhaust Gas Recirculation Sensor B Circuit High
What To Check After Fixing 28941 Code
- Inspect all the connections exhaust bank 4 mixture adaptation range 3, rich limit exceeded
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns