VW Code 28922
28922 Description And Summary : |
|---|
The problem is about throttle/pedal position sensor / switch 'f', circuit high to change the oil filter and use the recommended engine oil to avoid any problems in the future so transmission solenoid power relay, short to ground also exhaust turbocharger control module 1 (j724), voltage supply outside permissible range will delay your vw fault. |
28922 Possible Causes:
28922 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor B Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Reverse Input Circuit
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 28922 Code
- Inspect all the connections o2 sensor signal bank 2 sensor 1, biased / stuck rich
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns