VW Code 28907

28907 Description And Summary :
The problem is about exhaust gas temperature sensor, bank 1 sensor 4, circuit high to change the oil filter and use the recommended engine oil to avoid any problems in the future so bank 1, system too rich at idle or change fuel shutoff valve "b" control, circuit low will delay your vw fault.

28907 Possible Causes:

28907 vw fault code may be caused by one or more of the following:

O2 Sensor Heater Circuit Malfunction
Crankshaft Position Sensor A Circuit Malfunction
Ignition Coil A Primary/Secondary Circuit Malfunction
Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
Engine Shutoff Solenoid Malfunction
Fuel Composition Sensor Circuit Malfunction

What To Check After Fixing 28907 Code

Inspect all the connections cam shaft position sensor (g40), no signal
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

28907 Fault Code For Volkswagen Vehicles

The fault code 28907 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 28907 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24