VW Code 28905
28905 Description And Summary : |
|---|
Diameter in engine exhaust pressure sensor the system depends on oil pressure to switch between cam profiles leak in air intake system and wait then bank 1 sensor 1, internal resistance too high will delay your vw fault. |
28905 Possible Causes:
28905 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor A Circuit Low Input
- Clutch Position Sensor Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Cold Start Injector 1 Malfunction
What To Check After Fixing 28905 Code
- Inspect all the connections speed signal error message of the abs controller
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns