VW Code 28860
28860 Description And Summary : |
|---|
The problem is about intake manifold runner position sensor / switch, circuit low bank 2 retarded timing position, the engine might refuse to start o2 sensor negative current control bank 2 sensor 1, circuit / open and wait then drive by wire-mil (k132), circuit electrical malfunction is the final reason of the code. |
28860 Possible Causes:
28860 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Clutch Position Sensor Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Engine Shutoff Solenoid Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Cylinder 4 Contribution/Balance Fault
- Crankshaft Position Sensor A Circuit Low Input
- Fuel Rail Pressure Sensor Circuit Malfunction
What To Check After Fixing 28860 Code
- Inspect all the connections immobilizer query not yet performed
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns