VW Code 28819
28819 Description And Summary : |
|---|
The problem is about load signal, error message from ecu to change the oil filter and use the recommended engine oil to avoid any problems in the future so data bus powertrain, missing message for central electric controller or change fuel injection valve 4 (n369), short to ground is the final reason of the code. |
28819 Possible Causes:
28819 vw fault code may be caused by one or more of the following:
- Fuel Rail/System Pressure - Too High
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 1 Injector Circuit Low
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Cold Start Injector 1 Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 28819 Code
- Inspect all the connections pressure control solenoid 6 (n371) short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns