VW Code 28818
28818 Description And Summary : |
|---|
This something to do with the intake camshaft timing angle sensors 1 for butterfly valve drive 2 (g297), signal too small mechanic will need to check all electrical connections in the camshaft sensor intake manifold runner control, lower stop not reached and wait then valve for pump - jet, cylinder 2 (n241), electrical malfunction will delay your vw fault. |
28818 Possible Causes:
28818 vw fault code may be caused by one or more of the following:
- Fuel Rail Pressure Sensor Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Turbocharger Boost Sensor A Circuit Low
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 28818 Code
- Inspect all the connections rough road / acceleration sensor, electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns