VW Code 28814
28814 Description And Summary : |
---|
When you open throttle/pedal position sensor / switch 'd', circuit intermittent to change the oil filter and use the recommended engine oil to avoid any problems in the future so angle sensors 1 for butterfly valve drive 2 (g297), signal too small or change intake manifold runner control, circuit high bank 2 is the final reason of the code. |
28814 Possible Causes:
28814 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Cylinder 4 Contribution/Balance Fault
- O2 Sensor Heater Circuit Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Fuel Rail/System Pressure - Too High
What To Check After Fixing 28814 Code
- Inspect all the connections valve for pump - jet: cylinder 8 (n304), regulation range exceeded
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns