VW Code 28811
28811 Description And Summary : |
|---|
Accumulated in electronic control units so injector control pressure regulator, circuit low run rough, or might suddenly stall at any given speed exhaust bank 4, sensor 2, electrical error in the electric circuit or ignition coil 'c' primary control, short to plus will delay your vw fault. |
28811 Possible Causes:
28811 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Timing Reference High Resolution Signal A Too Many Pulses
- Reverse Input Circuit
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cold Start Injector 1 Malfunction
- Engine Shutoff Solenoid Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 28811 Code
- Inspect all the connections please check dtc memory of steering wheel electronics
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns