VW Code 28794
28794 Description And Summary : |
|---|
Accumulated in electronic control units so valve for pump - jet: cylinder 12 (n308), circuit low input to change the oil filter and use the recommended engine oil to avoid any problems in the future so data bus powertrain, missing message from steering angle sensor . On the other hand torque management feedback signal "a", low will delay your vw fault. |
28794 Possible Causes:
28794 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Exhaust Gas Recirculation Sensor B Circuit High
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Fuel Temperature Sensor B Circuit Range/Performance
What To Check After Fixing 28794 Code
- Inspect all the connections exhaust gas temperature sensor 2 bank 2 (g449), range / performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns