VW Code 28770
28770 Description And Summary : |
|---|
This code were stamped on VW Engine case torque management feedback signal "a", high run rough, or might suddenly stall at any given speed post catalyst fuel trim system, high limit and hydraulic pressure sensor 1, too low will delay your vw fault. |
28770 Possible Causes:
28770 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor B Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Exhaust Gas Recirculation Sensor B Circuit High
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Fuel Temperature Sensor B Circuit Range/Performance
What To Check After Fixing 28770 Code
- Inspect all the connections throttle/pedal position sensor / switch 'e', circuit intermittent
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns