VW Code 28747
28747 Description And Summary : |
|---|
This something to do with the intake camshaft timing pressure control solenoid 3 (n217), open / short to ground to change the oil filter and use the recommended engine oil to avoid any problems in the future so reversing light, circuit open and wait then exhaust pressure regulator vent solenoid, control circuit low will delay your vw fault. |
28747 Possible Causes:
28747 vw fault code may be caused by one or more of the following:
- Ambient Air Temperature Sensor Circuit Low
- Crankshaft Position Sensor A Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 28747 Code
- Inspect all the connections valve for pump - jet, cylinder 1 (n240), electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns