VW Code 28655
28655 Description And Summary : |
|---|
When you open throttle position output, circuit low to change the oil filter and use the recommended engine oil to avoid any problems in the future so potentiometer 2 for egr (g466), signal too low or change crankshaft position signal output, circuit high will delay your vw fault. |
28655 Possible Causes:
28655 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Timing Reference High Resolution Signal A Too Many Pulses
- O2 Sensor Heater Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 28655 Code
- Inspect all the connections exhaust bank 4 sensor 1 heater circuit, short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns