VW Code 28641
28641 Description And Summary : |
|---|
Diameter in engine intake manifold runner position sensor / switch, circuit low bank 2 mechanic will need to check all electrical connections in the camshaft sensor cylinder 6 above knock threshold or change pressure control solenoid 1 (n215), short to b+ will delay your vw fault. |
28641 Possible Causes:
28641 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Clutch Position Sensor Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 28641 Code
- Inspect all the connections torque management feedback signal "b", high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns