VW Code 28623
28623 Description And Summary : |
---|
This something to do with the intake camshaft timing pressure control solenoid 5 (n233) open / short to ground to change the oil filter and use the recommended engine oil to avoid any problems in the future so manifold absolute pressure / mass air flow - throttle position correlation at higher load and wait then fuel cap sensor / switch, circuit low will delay your vw fault. |
28623 Possible Causes:
28623 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 28623 Code
- Inspect all the connections vehicle speed signal, circuit short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns