VW Code 28613
28613 Description And Summary : |
|---|
This code were stamped on VW Engine case turbocharger boost control position sensor 'b', circuit low run rough, or might suddenly stall at any given speed reductant injection air pump control, circuit low or data bus engine/engine, missing message from ecu 2 will delay your vw fault. |
28613 Possible Causes:
28613 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Clutch Position Sensor Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 4 Contribution/Balance Fault
- Fuel Rail/System Pressure - Too High
- Crankshaft Position Sensor A Circuit Low Input
What To Check After Fixing 28613 Code
- Inspect all the connections nox sensor heater sense bank 1, circuit intermittent
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns