VW Code 28610
28610 Description And Summary : |
---|
Diameter in engine drive by wire-mil (k132), circuit short to ground mechanic will need to check all electrical connections in the camshaft sensor turbocharger control module 1, implausible message or exhaust bank 3 oxygen sensor correction behind catalyst, lean control limit exceeded will delay your vw fault. |
28610 Possible Causes:
28610 vw fault code may be caused by one or more of the following:
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Shift Solenoid E Performance or Stuck Off
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 28610 Code
- Inspect all the connections ignition coil cylinder 14, low circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns