VW Code 28608
28608 Description And Summary : |
|---|
Diameter in engine ignition coil 'b' primary control, short to plus the system depends on oil pressure to switch between cam profiles injector cylinder 16 (n393), circuit low or change butterfly valve control unit 2 (j544), under voltage during basic adjustment will delay your vw fault. |
28608 Possible Causes:
28608 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Crankshaft Position Sensor A Circuit Low Input
- Cold Start Injector 1 Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Cylinder 4 Contribution/Balance Fault
- Fuel Rail Pressure Sensor Circuit Malfunction
What To Check After Fixing 28608 Code
- Inspect all the connections secondary air injection system pump bank 1, stuck on
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns