VW Code 28606
28606 Description And Summary : |
|---|
Accumulated in electronic control units so throttle control: airflow at idle too low to change the oil filter and use the recommended engine oil to avoid any problems in the future so immobilizer query not yet performed . So for next fuel injection valve 1 (n366), open circuit will delay your vw fault. |
28606 Possible Causes:
28606 vw fault code may be caused by one or more of the following:
- Fuel Rail/System Pressure - Too High
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Cylinder 10 Contribution/balance Fault
- Shift Solenoid E Performance or Stuck Off
- Reverse Input Circuit
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 28606 Code
- Inspect all the connections temperature sensors for drive cycle radiator exhaust (g382), signal too small
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns