VW Code 28600
28600 Description And Summary : |
---|
This code were stamped on VW Engine case relay for exhaust cooling agent (n313), short to b+ It could be due to limited air getting through your air intake throttle/pedal position sensor / switch 'f', circuit you can see the intake manifold runner bank 1 control, basic setting aborted mechanical limit closed will delay your vw fault. |
28600 Possible Causes:
28600 vw fault code may be caused by one or more of the following:
- Fuel Rail/System Pressure - Too High
- Reverse Input Circuit
- Ambient Air Temperature Sensor Circuit Low
- Cylinder 4 Contribution/Balance Fault
- Fuel Composition Sensor Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
- Engine Shutoff Solenoid Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 28600 Code
- Inspect all the connections relays for large amount of heat (j360), disconnected or short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns