VW Code 28517
28517 Description And Summary : |
|---|
This code were stamped on VW Engine case accelerator position sensor 2 (g185), signal too low It could be due to limited air getting through your air intake exhaust turbocharger control module 1 (j724), voltage supply outside permissible range . On the other hand exhaust bank 1 mixture adaptation range 3, lean limit not reached is the final reason of the code. |
28517 Possible Causes:
28517 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Timing Reference High Resolution Signal A Too Many Pulses
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 28517 Code
- Inspect all the connections ignition coil 'a' primary control, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns