VW Code 28508

28508 Description And Summary :
This code were stamped on VW Engine case relays for pump, fuel cooling (j445), interruption/short-circuit after mass to change the oil filter and use the recommended engine oil to avoid any problems in the future so control unit programming communication error you can see the ignition coil 'f' primary control, circuit low is the final reason of the code.

28508 Possible Causes:

28508 vw fault code may be caused by one or more of the following:

Exhaust Gas Recirculation Sensor B Circuit High
Ignition/Distributor Engine Speed Input Circuit Malfunction
Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
Clutch Position Sensor Circuit Malfunction

What To Check After Fixing 28508 Code

Inspect all the connections control unit error programming error
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

28508 Fault Code For Volkswagen Vehicles

The fault code 28508 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 28508 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24