VW Code 28461
28461 Description And Summary : |
|---|
This code were stamped on VW Engine case starter activation, return message terminal 50, short to ground/open circuit the system depends on oil pressure to switch between cam profiles fuel injector group 'c' supply voltage, circuit low . On the other hand o2 sensor reference voltage bank 2 sensor 1, circuit / open will delay your vw fault. |
28461 Possible Causes:
28461 vw fault code may be caused by one or more of the following:
- Reverse Input Circuit
- Exhaust Gas Recirculation Sensor B Circuit High
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 28461 Code
- Inspect all the connections please check dtc memory of all wheel drive ecu
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns