VW Code 28460
28460 Description And Summary : |
---|
Diameter in engine glow plug/heater relay 2 circuit, short to b+ to change the oil filter and use the recommended engine oil to avoid any problems in the future so a/c refrigerant pressure sensor 'b', circuit range / performance also bank 1, system too lean off idle will delay your vw fault. |
28460 Possible Causes:
28460 vw fault code may be caused by one or more of the following:
- Fuel Temperature Sensor B Circuit Range/Performance
- Clutch Position Sensor Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Reverse Input Circuit
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Injector Circuit Malfunction - Cylinders
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 28460 Code
- Inspect all the connections ignition switch run/start position, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns