VW Code 28458

28458 Description And Summary :
Diameter in engine cam shaft position sensor (g40), signal outside of the tolerance mechanic will need to check all electrical connections in the camshaft sensor data bus powertrain, missing message from steering angle sensor or combustion detection during deceleration will delay your vw fault.

28458 Possible Causes:

28458 vw fault code may be caused by one or more of the following:

Timing Reference High Resolution Signal A Too Many Pulses
Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
Crankshaft Position Sensor A Circuit Low Input
Glow Plug/Heater Circuit 'A' Malfunction
Engine Shutoff Solenoid Malfunction

What To Check After Fixing 28458 Code

Inspect all the connections transmission control unit, incorrect coded
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

28458 Fault Code For Volkswagen Vehicles

The fault code 28458 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 28458 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24