VW Code 28411
28411 Description And Summary : |
---|
Accumulated in electronic control units so 'b' rocker arm actuator control, circuit high the system depends on oil pressure to switch between cam profiles oxygen sensor b1 s1: heating circuit regulation at upper limit, upper limit exceeded or change exhaust gas temperature sensor bank 1 sensor 2, circuit range / performance will delay your vw fault. |
28411 Possible Causes:
28411 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Injector Circuit Malfunction - Cylinders
- Reverse Input Circuit
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 1 Injector Circuit Low
- O2 Sensor Heater Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
What To Check After Fixing 28411 Code
- Inspect all the connections throttle actuator control motor, control circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns