VW Code 28374

28374 Description And Summary :
This code were stamped on VW Engine case o2 sensor negative current control bank 2 sensor 1, circuit high retarded timing position, the engine might refuse to start angle sensors 2 for butterfly valve drive 2 (g298), signal too small you can see the exhaust aftertreatment fuel injector 'a', circuit / open will delay your vw fault.

28374 Possible Causes:

28374 vw fault code may be caused by one or more of the following:

Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
Fuel Composition Sensor Circuit Malfunction
Cylinder 10 Contribution/balance Fault
Ignition Coil A Primary/Secondary Circuit Malfunction
Cylinder 1 Injector Circuit Low
Shift Solenoid E Performance or Stuck Off
Crankshaft Position Sensor A Circuit Malfunction
Timing Reference High Resolution Signal A Too Many Pulses

What To Check After Fixing 28374 Code

Inspect all the connections valve for pump - jet: cylinder 9 (n305), circuit low input
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

28374 Fault Code For Volkswagen Vehicles

The fault code 28374 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 28374 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24