VW Code 28361
28361 Description And Summary : |
|---|
This code were stamped on VW Engine case ignition switch run/start position, circuit retarded timing position, the engine might refuse to start hydraulic actuator position sender (g302), upper limit exceeded . On the other hand 'b' rocker arm actuator system, performance or stuck off is the final reason of the code. |
28361 Possible Causes:
28361 vw fault code may be caused by one or more of the following:
- Fuel Composition Sensor Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Timing Reference High Resolution Signal A Too Many Pulses
- Crankshaft Position Sensor A Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 28361 Code
- Inspect all the connections vacuum reservoir pressure sensor, circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns