VW Code 28349
28349 Description And Summary : |
---|
This something to do with the intake camshaft timing signal 'door up' not recognized to change the oil filter and use the recommended engine oil to avoid any problems in the future so torque management request input signal a, low and intake manifold runner control, circuit / open bank 2 will delay your vw fault. |
28349 Possible Causes:
28349 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Turbocharger Boost Sensor A Circuit Low
- Cylinder 1 Injector Circuit Low
- Cylinder 10 Contribution/balance Fault
- Fuel Composition Sensor Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Cold Start Injector 1 Malfunction
What To Check After Fixing 28349 Code
- Inspect all the connections supply voltage for fuel injector group b, short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns