VW Code 28347
28347 Description And Summary : |
---|
Staring in engine throttle position (tp) sensor 1-2, correlation the system depends on oil pressure to switch between cam profiles throttle/pedal position sensor 'c', maximum stop performance and wait then pressure control solenoid 3 (n217), electrical malfunction is the final reason of the code. |
28347 Possible Causes:
28347 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Clutch Position Sensor Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Cold Start Injector 1 Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Ambient Air Temperature Sensor Circuit Low
- Turbocharger Boost Sensor A Circuit Low
- Shift Solenoid E Performance or Stuck Off
What To Check After Fixing 28347 Code
- Inspect all the connections relays for pump load air cooling (j536), interruption / short-circuit after mass
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns