VW Code 28330
28330 Description And Summary : |
|---|
This code were stamped on VW Engine case ignition coil 'k' primary control, circuit low run rough, or might suddenly stall at any given speed linear oxygen sensor exhaust bank 4 / common ground wire, open circuit and o2 sensor pumping current trim bank 1 sensor 1, circuit / open will delay your vw fault. |
28330 Possible Causes:
28330 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Timing Reference High Resolution Signal A Too Many Pulses
- Clutch Position Sensor Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
- Fuel Rail/System Pressure - Too High
What To Check After Fixing 28330 Code
- Inspect all the connections shift lock, malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns