VW Code 28307

28307 Description And Summary :
Accumulated in electronic control units so starter relay 2, electrical malfunction in circuit (relay stuck / does not switch) to change the oil filter and use the recommended engine oil to avoid any problems in the future so ignition coil 'c' primary control, short to plus . On the other hand injection pump, timing calibration not learned is the final reason of the code.

28307 Possible Causes:

28307 vw fault code may be caused by one or more of the following:

Timing Reference High Resolution Signal A Too Many Pulses
Shift Solenoid E Performance or Stuck Off
Exhaust Gas Recirculation Sensor B Circuit High
Cylinder 4 Contribution/Balance Fault
Ambient Air Temperature Sensor Circuit Low
Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
Clutch Position Sensor Circuit Malfunction

What To Check After Fixing 28307 Code

Inspect all the connections intake manifold runner position sensor / switch, circuit low bank 2
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

28307 Fault Code For Volkswagen Vehicles

The fault code 28307 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 28307 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24