VW Code 28288
28288 Description And Summary : |
---|
Diagnosing engine bar with pressure control solenoid 2 (n216), short to b+ to change the oil filter and use the recommended engine oil to avoid any problems in the future so a/c control module requested, mil illumination or change throttle position output, circuit / open is the final reason of the code. |
28288 Possible Causes:
28288 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Fuel Rail Pressure Sensor Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Cylinder 10 Contribution/balance Fault
- Crankshaft Position Sensor A Circuit Low Input
- Ignition/Distributor Engine Speed Input Circuit Malfunction
What To Check After Fixing 28288 Code
- Inspect all the connections linear oxygen sensor exhaust bank 3 / common ground wire, open circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns