VW Code 28260
28260 Description And Summary : |
|---|
This code were stamped on VW Engine case data bus powertrain, missing message from a/c controller causes include a bad boost pressure sensor or a vacuum leak in the system fuel pump, mechanical malfunction . On the other hand 'a' rocker arm actuator control, circuit high will delay your vw fault. |
28260 Possible Causes:
28260 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- O2 Sensor Heater Circuit Malfunction
What To Check After Fixing 28260 Code
- Inspect all the connections fuel injector group 'c' supply voltage, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns