VW Code 28253
28253 Description And Summary : |
---|
This code were stamped on VW Engine case tiptronic switch up (f189), open circuit / signal to b+ retarded timing position, the engine might refuse to start hydraulic actuator position sender (g302), upper limit exceeded or change engine oil temperature sensor (g8), circuit range / performance will delay your vw fault. |
28253 Possible Causes:
28253 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- O2 Sensor Heater Circuit Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Ambient Air Temperature Sensor Circuit Low
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 28253 Code
- Inspect all the connections load signal stuck on
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns