VW Code 28247
28247 Description And Summary : |
|---|
This something to do with the intake camshaft timing cylinder 2 above knock threshold the system depends on oil pressure to switch between cam profiles cooling bypass valve 2, exhaust gas recirculation flow, electrical or change clutch pedal position (cpp) switch (f194), implausible signal will delay your vw fault. |
28247 Possible Causes:
28247 vw fault code may be caused by one or more of the following:
- O2 Sensor Heater Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Engine Shutoff Solenoid Malfunction
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 28247 Code
- Inspect all the connections ignition coil 'e' primary control, short to plus
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns