VW Code 28244
28244 Description And Summary : |
|---|
Diameter in engine ignition switch run position, circuit retarded timing position, the engine might refuse to start torque management request input signal b, low you can see the fuel cap sensor / switch, circuit range / performance will delay your vw fault. |
28244 Possible Causes:
28244 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 10 Contribution/balance Fault
- Reverse Input Circuit
- Glow Plug/Heater Circuit 'A' Malfunction
- Clutch Position Sensor Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 28244 Code
- Inspect all the connections o2 sensor signal bank 1 sensor 3, biased / stuck rich
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns