VW Code 28243
28243 Description And Summary : |
---|
When you open actuator supply voltage 'c', circuit low the system depends on oil pressure to switch between cam profiles pressure control solenoid 5 (n233) short to b+ . On the other hand shift up/down wire, short to b+ will delay your vw fault. |
28243 Possible Causes:
28243 vw fault code may be caused by one or more of the following:
- Glow Plug/Heater Circuit 'A' Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Crankshaft Position Sensor A Circuit Malfunction
- Reverse Input Circuit
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 28243 Code
- Inspect all the connections data bus powertrain, implausible message of the awd control module
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns