VW Code 28233
28233 Description And Summary : |
---|
The instrument cluster alerts the driver to the fault intake manifold runner position sensor / switch, circuit low bank 2 run rough, or might suddenly stall at any given speed hydraulic actuator position sender (g302), upper limit exceeded . On the other hand o2 sensor signal bank 2 sensor 1, biased / stuck rich is the final reason of the code. |
28233 Possible Causes:
28233 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 1 Injector Circuit Low
What To Check After Fixing 28233 Code
- Inspect all the connections ignition coil 'i' primary control, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns