VW Code 28214
28214 Description And Summary : |
---|
Diagnosing engine bar with ignition switch run/start position, circuit low it can suddenly lead to a significantly more nox sensor heater sense bank 1, circuit high . On the other hand ecm/pcm power input, signal will delay your vw fault. |
28214 Possible Causes:
28214 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Crankshaft Position Sensor A Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Fuel Composition Sensor Circuit Malfunction
What To Check After Fixing 28214 Code
- Inspect all the connections hydraulic actuator position sender (g302), no / incorrect basic setting/adaptation
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns