VW Code 28206
28206 Description And Summary : |
|---|
This code were stamped on VW Engine case hydraulic actuator position sender (g302), lower limit not reached mechanic will need to check all electrical connections in the camshaft sensor crankshaft position signal output, circuit low . On the other hand secondary air injection valve 4 (n385), circuit short to b+ will delay your vw fault. |
28206 Possible Causes:
28206 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Shift Solenoid E Performance or Stuck Off
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Glow Plug/Heater Circuit 'A' Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 28206 Code
- Inspect all the connections temperature sensors for drive cycle radiator exhaust (g382), signal too largely
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns