VW Code 28204
28204 Description And Summary : |
|---|
This code were stamped on VW Engine case relays for small amount of heat (j359), disconnected or short to ground retarded timing position, the engine might refuse to start engine coolant temperature sensor 2 (g83), circuit intermittent / erratic . On the other hand ignition switch run/start position, circuit is the final reason of the code. |
28204 Possible Causes:
28204 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Cylinder 4 Contribution/Balance Fault
- Shift Solenoid E Performance or Stuck Off
- Fuel Composition Sensor Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
What To Check After Fixing 28204 Code
- Inspect all the connections injector control pressure, erratic
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns