VW Code 28192
28192 Description And Summary : |
|---|
When you open relays for large amount of heat (j360), disconnected or short to ground retarded timing position, the engine might refuse to start control module defective or change linear oxygen sensor exhaust bank 4 / reference voltage, short to ground is the final reason of the code. |
28192 Possible Causes:
28192 vw fault code may be caused by one or more of the following:
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Clutch Position Sensor Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 28192 Code
- Inspect all the connections intake flap motor 2 (v275), faulty
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns