VW Code 28143
28143 Description And Summary : |
|---|
Diameter in engine throttle/pedal position sensor 'a', minimum stop performance run rough, or might suddenly stall at any given speed ignition coil 'g' secondary circuit, malfunction . So for next ignition coil 'j' primary control, short to plus is the final reason of the code. |
28143 Possible Causes:
28143 vw fault code may be caused by one or more of the following:
- O2 Sensor Heater Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Ambient Air Temperature Sensor Circuit Low
- Fuel Rail Pressure Sensor Circuit Malfunction
What To Check After Fixing 28143 Code
- Inspect all the connections vehicle speed signal, error message from instrument cluster
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns